top of page

Control Head Mount Bracket, Autohelm Autopilot 2000, 3000, 4000, ST3000

In stock
Product Details

Control head mount bracket for the Autohelm 2000, 3000, 4000 and ST3000 autopilots in WHITE nylon PA12 - beautiful resolution - vastly better than any 'hobby' 3D printer can produce. White is nice on a fibreglass hull.

Bracket dimensions: 8cm W x 6.1cm H or 3.15"W x 2.5"H

*** IMPORTANT: This bracket looks very similar to the Autohelm analog 3000 bracket ***

Please check the photos of the autopilots that this bracket is for!

This 3D printed replacement for the bracket is redesigned to be much stronger and printed in Nylon PA12. Available in white (nice on a fibreglass hull).

You'll notice this bracket does not have the rectangular holes through the bracket reproduced. Those holes were only there for injection molding the part, contributed to its breakage, and are not needed in 3D printing.

The original part number is D098. See the picture showing the control unit which this bracket works with.

Save this product for later
bottom of page